Specification For Low Voltage Switchgear And Controlgear
1. SCOPE
This specification defines the requirements for the design, manufacture and works testing of indoor assemblies of low-voltage, metal-enclosed switchgear and
controlgear operated at voltages up to and including 1kV and intended for use on the PROJECT-NAME projects (hereafter referred to as ‘the Project’)
2. CODES, STANDARDS AND SPECIFICATIONS
2.1 General
The electrical equipment and installation shall conform in design, materials and performance, except where otherwise specified, with the current issue and amendments of the Codes and Standards specified by the International Electrotechnical Commission (IEC).
All conflicts between the requirements of this specification and other relevant documents shall be referred to the Buyer for resolution.
Specification for Liquid Immersed Power Transformers 500 kVA – 10,000 kVA Up To 34.5 kV HV Winding
1. SCOPE
This document defines the requirements for design, manufacture and testing of oil filled transformers intended for use on the PCO OIL Projects in Iraq.
2. CODES AND STANDARDS
2.1 General
The electrical equipment and installation shall conform in design, materials and performance, except where otherwise specified, with the current issue
and amendments of the Codes and Standards specified by the International Electrotechnical Commission (IEC).
All conflicts between the requirements of this specification and other relevant documents shall be referred to the Buyer for resolution.
Specification For High Voltage Induction Motors
SCOPE
This document defines the requirements for design, manufacture and testing of high voltage squirrel cage induction motors for PROJECT-NAME Project.
2. CODES AND STANDARDS
2.1 General
The electrical equipment and installation shall conform in design, materials and performance, except where otherwise specified, with the current issue and amendments
of the Codes and Standards specified in the following sections.
International Codes and Standards shall be used as the prime specification. Compliance by the Vendor with this specification does not relieve him of his
responsibility to supply equipment suited to meet the specified service conditions. All conflicts between the requirements of this specification and other relevant documents
shall be referred to the Company for resolution.
Specification for igh-Voltage Metal-Clad / Metal-Enclosed Switchgear
 SCOPE
This specification defines the requirements for the design, manufacture and works testing of indoor assemblies of high-voltage metal-clad, metal-enclosed switchgear operated at voltages up to and including 35kV and intended for use on the PROJECT-NAME projects (hereafter referred to as ‘the Project’).
CODES, STANDARDS AND SPECIFICATIONS
2.1 General
The electrical equipment and installation shall conform in design, materials and performance, except where otherwise specified, with the current issue and amendments of the Codes and Standards specified by the International
Electrotechnical Commission (IEC).
All conflicts between the requirements of this specification and other relevant documents shall be referred to the Buyer for resolution.